 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Boeing Troubleshooting Experts Fix Space Shuttle In-Flight Anomalies
Houston TX (SPX) Jan 26, 2006 When something as complex as the Space Shuttle flies, there are unexpected circumstances known as In-Flight Anomalies (IFAs) that a team of Boeing, United Space Alliance (USA) and NASA engineers investigate and resolve after each flight. IFAs have occurred on every Space Shuttle flight and Boeing, as the original manufacturer of the Orbiters, often has the responsibility of investigating and resolving them as part of its contract with United Space Alliance. Tim Reith, Boeing Orbiter Integration manager and deputy chief engineer, says although it's not unusual to have IFAs on every flight, they must be fully understood before the next flight. "When we have an unexpected result, we'll investigate and troubleshoot for the given conditions on whether the hardware acted properly," said Reith. "If the problem can be isolated to a specific piece of hardware, then it will be replaced with a spare. For situations deemed "unexplained" because the root cause cannot be determined, or if we can't recreate an IFA, we do a thorough assessment of all the things that could happen and determine if we have sufficient redundancy and work-arounds and measure the level of risk.". In unexplained cases NASA makes the ultimate decision to accept that risk. Following the Columbia accident, NASA rewrote the definition of IFAs and, as a result, more were listed on the last flight. The process of troubleshooting an IFA begins as soon as Boeing engineers learn about the problem. "We'll start looking at it right away to determine the impact to the mission," said Reith. "For many of the problems, if there is not a big impact we can often wait until the Shuttle lands to troubleshoot." All IFAs on the last flight had either a workaround or could be accepted as is with no safety impact. Troubleshooting usually begins with engineers trying to recreate the problems on the ground to isolate and narrow down the problem further. Problem resolution teams define troubleshooting procedures to get a better understanding of the failure. "If we are successful, then the component is replaced and we go into an investigative phase to figure out why the component failed," said Reith. "Traveling to space is a complicated engineering marvel and we do all we can to make it as safe as possible. Working with NASA and USA on IFAs is just one example of a robust process designed into the Shuttle program," added Reith.
Boeing Engineers Assist NASA In Shuttle Tile Work On the last Shuttle mission, two gap fillers were protruding about an inch between the tiles and had to be removed during a spacewalk when analysis showed it could cause increased heating on the Thermal Protection System (TPS) during reentry into the Earth's atmosphere. Determining what caused the gap fillers to come out took a little detective work by an integrated team of Boeing, NASA and USA engineers. "The first thing we looked at was the installation process," said Dan Bell, Boeing TPS subsystem manager. There were multiple possible contributing causes why some of the gap fillers were found with various protrusions after the last flight. The cause was narrowed down to the installation process and a new method was developed. Work is underway on the vehicles to remove those gap fillers. NASA expects to have them removed and replaced on both Atlantis and Discovery in the priority one region (subjected to higher heating) before the next shuttle flight. "We ended up saving about 15 percent of those gap fillers that were installed with the old process, while all others in our first priority region were replaced," said Bell. About 3,000 gap fillers will be replaced in the priority one area. Bell says all gap fillers will be eventually checked and replaced if needed. "These changes have made all the difference. It has been a real success," Bell said. Community Email This Article Comment On This Article Related Links United Space Alliance Boeing Space Shuttle News at Space-Travel.Com
NASA Awards Shuttle/Space Station Engineering Support Contract
Houston TX (SPX) Jan 19, 2006NASA has awarded a $34 million contract to The Charles Stark Draper Laboratory in Cambridge, Mass., to provide engineering development and analysis for the space shuttle and International Space Station. The work will support the guidance, navigation, control and integrated avionics systems of the shuttle and station. |
|
|
| The content herein, unless otherwise known to be public domain, are Copyright 1995-2006 - SpaceDaily.AFP and UPI Wire Stories are copyright Agence France-Presse and United Press International. ESA PortalReports are copyright European Space Agency. All NASA sourced material is public domain. Additionalcopyrights may apply in whole or part to other bona fide parties. Advertising does not imply endorsement,agreement or approval of any opinions, statements or information provided by SpaceDaily on any Web page published or hosted by SpaceDaily. Privacy Statement |
