Subscribe free to our newsletters via your
. Energy News .




ENERGY TECH
Dry-run experiments verify key aspect of Sandia nuclear fusion concept
by Staff Writers
Albuquerque NM (SPX) Sep 18, 2012


Sandia researcher Ryan McBride pays close attention to the tiny central beryllium liner to be imploded by the powerful magnetic field generated by Sandia's Z machine. The larger cylinders forming a circle on the exterior of the base plate measure Z's load current by picking up the generated magnetic field. Credit: Courtesy, Sandia National Laboratories (Photo by Randy Montoya).

Magnetically imploded tubes called liners, intended to help produce controlled nuclear fusion at scientific "break-even" energies or better within the next few years, have functioned successfully in preliminary tests, according to a Sandia research paper accepted for publication by Physical Review Letters (PRL).

To exceed scientific break-even is the most hotly sought-after goal of fusion research, in which the energy released by a fusion reaction is greater than the energy put into it - an achievement that would have extraordinary energy and defense implications.

That the liners survived their electromagnetic drubbing is a key step in stimulating further Sandia testing of a concept called MagLIF (Magnetized Liner Inertial Fusion), which will use magnetic fields and laser pre-heating in the quest for energetic fusion.

In the dry-run experiments just completed, cylindrical beryllium liners remained reasonably intact as they were imploded by huge magnetic field of Sandia's Z machine, the world's most powerful pulsed-power accelerator.

Had they overly distorted, they would have proved themselves incapable of shoveling together nuclear fuel - deuterium and possibly tritium - to the point of fusing them. Sandia researchers expect to add deuterium fuel in experiments scheduled for 2013.

"The experimental results - the degree to which the imploding liner maintained its cylindrical integrity throughout its implosion - were consistent with results from earlier Sandia computer simulations," said lead researcher Ryan McBride."These predicted MagLIF will exceed scientific break-even."

A simulation published in a 2010 Physics of Plasmas article by Sandia researcher Steve Slutz showed that a tube enclosing preheated deuterium and tritium, crushed by the large magnetic fields of the 25-million-ampere Z machine, would yield slightly more energy than is inserted into it.

A later simulation, published last January in PRL by Slutz and Sandia researcher Roger Vesey, showed that a more powerful accelerator generating 60 million amperes or more could reach "high-gain" fusion conditions, where the fusion energy released greatly exceeds (by more than 1,000 times) the energy supplied to the fuel.

These goals - both the near-term goal of scientific break-even on today's Z machine and the long-term goal of high-gain fusion on a future, more powerful machine - require the metallic liners to maintain sufficient cylindrical integrity while they implode.

The liner is intended to contain fusion fuel like a can holds peanut butter, and push it together in nanoseconds like two semicylindrical shovels compacting snow together.

An element of drama is present because the metallic liner doing the compressing is also being eaten away as it conducts the Z machine's enormous electrical current along its outer surface.

This electrical current generates the corresponding magnetic field that crushes the liner, but under the stress of passing that current, the outer surface of the liner begins to vaporize and turn into plasma, in much the same way as a car fuse vaporizes when a short circuit sends too much current through it.

As this happens, the surface begins to lose integrity and becomes unstable. This instability works its way inward, toward the liner's inner surface, throughout the course of the implosion.

"You might say: The race is on," said McBride. "The question is, can we start off with a thick enough tube such that we can complete the implosion and burn the fusion fuel before the instability eats its way completely through the liner wall?

"A thicker tube would be more robust in standing up to this instability, but the implosion would be less efficient because Z would have to accelerate more liner mass. On the flip side, a thinner tube could be accelerated to a much higher implosion velocity, but then the instability would rip the liner to shreds and render it useless," he continues.

"Our experiments were designed to test a sweet spot predicted by the simulations where a sufficiently robust liner could implode with a sufficiently high velocity."

By following the dimensions proposed by the earlier simulations, the physical test proved successful and the liner walls maintained their integrity throughout the implosion.

Radiographs taken at nanosecond intervals depicted the implosion of the initially solid beryllium liner through to stagnation - the point at which an implosion stops because the liner material has reached the cylinder's central axis.

The images show the outer surface of the imploding liner distorting until it resembles threads on a bolt. However, the more crucial inner surface remains reasonably intact all the way through to stagnation.

Said McBride's manager Dan Sinars, "When Magnetized Liner Inertial Fusion was first proposed, our biggest concern was whether the instabilities would disrupt the target before fusion reactions could occur. We had complex computer simulations that suggested things would be OK, but we were not confident in those predictions.

"Then McBride did his experiments, using liners with the same dimensions as our simulations, and the outcomes matched. We are now confident enough to take the next steps on the Z facility of integrating in the new magnetic field and laser preheat capabilities that will be required to test the full concept. Consequently, we intend to take those first integration steps in 2013."

Slated for December are the first tests of the final two components of the MagLIF concept: laser preheating to put more energy into the fuel before magnetic compression begins, and the testing of two secondary electrical coils placed at the top and bottom of the can.

Their magnetic fields are expected to keep charged particles from escaping the hot fuel horizontally. This is crucial because if too many particles escape, the fuel could cool to the point where fusion reactions cease.

Sandia researchers intend to test the fully integrated MagLIF concept by the close of 2013.

"This work is one more step on a long path to possible energy applications," said Sandia senior manager Mark Herrmann.

The liner implosion experiments also served to verify that simulation tools like the popular LASNEX code are accurate within certain parameters, but may diverge when used beyond those limits - information of importance to other labs that use the same codes.

McBride will give an invited talk on his work this fall at the American Physical Society's annual Division of Plasma Physics meeting in Providence, RI. He is also preparing an invited paper for Physics of Plasmas to explain the PRL results in greater depth.

The work was funded by Sandia's Laboratory Directed Research and Development program and the National Nuclear Security Administration. Read more about this research here.

.


Related Links
DOE/Sandia National Laboratories
Powering The World in the 21st Century at Energy-Daily.com






Comment on this article via your Facebook, Yahoo, AOL, Hotmail login.

Share this article via these popular social media networks
del.icio.usdel.icio.us DiggDigg RedditReddit GoogleGoogle




Memory Foam Mattress Review
Newsletters :: SpaceDaily :: SpaceWar :: TerraDaily :: Energy Daily
XML Feeds :: Space News :: Earth News :: War News :: Solar Energy News





ENERGY TECH
Boon to fusion: Scientist finds new way to predict heat layer troublemaker
Princeton NJ (SPX) Aug 22, 2012
Researchers at a recent worldwide conference on fusion power have confirmed the surprising accuracy of a new model for predicting the size of a key barrier to fusion that a top scientist at the U.S. Department of Energy's Princeton Plasma Physics Laboratory (PPPL) has developed. The model could serve as a starting point for overcoming the barrier. "This allows you to depict the size of the ... read more


ENERGY TECH
Home sweet lab: Computerized house to generate as much energy as it uses

'Smart growth' strategies curb car use, greenhouse gas emissions

China to invest $3.5 bn in Zimbabwe power plant: report

EP passes sulfur fuel, efficiency bills

ENERGY TECH
EU MPs call for 'robust' oversight of shale gas development

Dry-run experiments verify key aspect of Sandia nuclear fusion concept

Rosneft's Cooperates with Eni and Statoil in the Arctic

Japan calls for reform of LNG markets

ENERGY TECH
Sufficient wind energy available to meet global demands without damaging climate

Report backs greater role for wind energy

Wind could meet many times world's total power demand by 2030

High-altitude winds have large potential as a source of clean energy

ENERGY TECH
China solar dumping a topic for EU talks?

Hanwha Solar Enters Distribution Partnership with AEE Solar

Retail Complex Goes Solar With 1,196 Solar PV Panel System from Eclipsall

The UK's first solar powered major waste treatment plant

ENERGY TECH
Japan gets new nuclear watchdog

Japan to retreat from nuclear power

Japan says to phase out nuclear energy by 2040

Nuclear Proliferation Risks Of Laser Enrichment Require Fuller NRC Review

ENERGY TECH
Sorghum Eyed as a Southern Bioenergy Crop

EU confirms change in biofuel targets

France reconsiders plans to boost biofuel use

World Energy and Hydro Dynamics team up to promote SPR cavitation reactor technology

ENERGY TECH
Tiangong Orbit Change Signals Likely Date for Shenzhou 10

China Focus: Timeline for China's space research revealed

China eyes next lunar landing as US scales back

China unveils ambitious space projects

ENERGY TECH
Effectiveness and impact of climate change mitigation measures unclear

U.S. underestimates costs of carbon pollution and climate change

Researchers emphasize evaluation of tradeoffs in battling urban heat island

Next generation of advanced climate models needed




The content herein, unless otherwise known to be public domain, are Copyright 1995-2014 - Space Media Network. AFP, UPI and IANS news wire stories are copyright Agence France-Presse, United Press International and Indo-Asia News Service. ESA Portal Reports are copyright European Space Agency. All NASA sourced material is public domain. Additional copyrights may apply in whole or part to other bona fide parties. Advertising does not imply endorsement,agreement or approval of any opinions, statements or information provided by Space Media Network on any Web page published or hosted by Space Media Network. Privacy Statement